Electronics Forum | Thu Dec 28 12:19:20 EST 2006 | slthomas
So I'm the only one that's had crappy piles of silkscreen between pads?
Electronics Forum | Thu Jul 10 07:48:40 EDT 2008 | realchunks
Try IPC SM 782. Also most parts manufacturers should be able to provide you a pad design.
Electronics Forum | Tue Jan 02 09:47:41 EST 2007 | slthomas
We had a supplier that put a [fuzzy and of variable height) line of ss between all chip R and C pads. Of course we were in low cost mode and had purchased a year's worth of boards.
Electronics Forum | Mon Jul 07 13:33:40 EDT 2008 | realchunks
Most QFP 128s have a 0.16mm wide lead. Might have to modify your pads if you'r buying some odd ball part. But generally 0.2mm should be OK for this part. You may never get good toe wetting. Most QFPs are cut apart after plating, thus the toes are
Electronics Forum | Mon Jul 07 11:46:29 EDT 2008 | aj
Hi All, Can anyone advise the spec for land size of a lead 0.2mm in width? I am placing a TQFP128 0.4mm pitch, the leads seem to be wider than the actual pads they are been placed on? I am also experiencing poor wetting on this part , it has NiPdAU
Electronics Forum | Thu Jan 30 06:44:20 EST 2003 | Grant Petty
Hi, Great, thanks for the info! Regards, Grant Petty Blackmagic Design www.blackmagic-design.com
Electronics Forum | Tue Apr 06 16:09:25 EDT 1999 | Dave F
| Hi, | Somebody know how to calculate the size of pads for different IC's: QFP's, SOIC, SOJ, etc. | | any help is apreciated. | | thanks | | AC | Al: Justin's comments are well taken. Who should know better about pad sizes that the component m
Electronics Forum | Tue Apr 06 09:42:08 EDT 1999 | Justin Medernach
| Hi, | Somebody know how to calculate the size of pads for different IC's: QFP's, SOIC, SOJ, etc. | | any help is apreciated. | | thanks | | AC | Hi AC, Recommended pad geometries come with component specs. Your circuit will be comprised of giv
Electronics Forum | Thu Jun 29 09:12:27 EDT 2000 | sree
What is the best aperture opening for micrBGA with 0.8 mm ball pitch and 16 mils ball diameter?The pad size on the PCB is 12 mils.
Electronics Forum | Sun Jan 26 21:09:32 EST 2003 | Grant Petty
Hi, Ok, thanks for the info, and I had not considered that factor. Is this an issue related to the reflow temperature change in the oven, or a temperature change in normal product use issue? I will check out the standard, and do you know where it's
